IT창고

[ KT ]

168.126.63.1   kns.kornet.net

168.126.63.2   kns2.kornet.net

[ LG Uplus ]

164.124.101.2   ns.dacom.co.kr

164.124.107.9   cns2.bora.net

203.248.240.31  ns2.dacom.net

[ SKT ]

210.220.163.82  bns1.hananet.net

219.250.36.130  bns2.hananet.net

Checked :  Windows 7, Windows 8.1, Windows Server 2012 R2.

(1) IP공유기의 WOL 설정란에 PC 랜카드의 MAC 주소 등록.

(2) PC 부팅시 BIOS로 진입한 후, 관련 메뉴 설정 (메인보드 종류에 따라 설정 메뉴가 다름)

     APM Configuraion > Power On by PCI Devices [Enabled]

     APM Configuraion > Power On by PCI-E Devices [Enabled]

     Wake On LAN [AC Only]

     PME Event Wake Up [Enabled]

     PXE OPROM [Always]

     ErP Support [Disabled]

       ※ Erp : GIGABYTE 전원관리 기술,

                 전원이 꺼진 상태(S5) 에서 1W 이하의 전기 소모,

                 전원버튼으로만 컴퓨터를 켤수 있음,

     EuP Control [Disabled]

        ※ EuP : Energe Using Peoduct,

                   유럽 연합(EU)에 의해 2005년 8월 발효한 에코디자인 관련 법규,

                   시스템 OFF시 대기전력이 1W 미만인 것을 규정.

(3) PC 랜카드 Driver의 속성 설정 (랜카드 종류에 따라 설정 메뉴가 다름)

(4) Windows 전원 옵션 설정 (데스크탑 버전일 경우 해당 옵션이 없을 수도 있음)

(5) 설정이 완료되었으면, PC가 종료된 상태로 IP공유기의 관리자 화면으로 접속하여,

     WOL 기능란의 PC켜기 실행.

Cisco Catalyst 2950 Switch 기본 정보 변경 명령어 입니다.

Switch> enable

Switch# configure terminal

Switch(config)# enable password cisco  // enable 모드 암호 설정.

Switch(config)# interface vlan1

Switch(config-if)# ip address 000.000.000.000 255.255.255.0  // 장비 관리용 IP주소 설정.

Switch(config-if)# no shutdown

Switch(config-if)# exit

Switch(config)# ip default-gateway 000.000.000.1  // 장비 기본 게이트웨이 주소 설정.

Switch(config)# ip http server  // 장비 관리용 웹콘솔 활성화.

Switch(config)# line vty 0 4  // Telnet 모드.

Switch(config-line)# password cisco  // Telnet 접속 암호 설정.

Switch(config-line)# exit

Switch(config)# end

Switch# write memory  // 설정값 저장.

Switch# exit

// 장비 전면 <MODE> 버튼을 누른 채, 뒷면 전원 케이블을 연결합니다.

C2950 Boot Loader (C2950-HBOOT-M) Version 12.1(11r)EA1, RELEASE SOFTWARE (fc1)
Compiled Mon 22-Jul-02 17:18 by antonino
WS-C2950C-24 starting...
Base ethernet MAC Address: 00:0f:90:81:98:00
Xmodem file system is available.

The system has been interrupted prior to initializing the
flash filesystem.  The following commands will initialize
the flash filesystem, and finish loading the operating
system software:

    flash_init
    load_helper
    boot

switch: flash_init

Initializing Flash...
flashfs[0]: 78 files, 3 directories
flashfs[0]: 0 orphaned files, 0 orphaned directories
flashfs[0]: Total bytes: 7741440
flashfs[0]: Bytes used: 5982208
flashfs[0]: Bytes available: 1759232
flashfs[0]: flashfs fsck took 7 seconds.
...done initializing flash.
Boot Sector Filesystem (bs:) installed, fsid: 3
Parameter Block Filesystem (pb:) installed, fsid: 4

switch: load_helper

switch: boot

Loading "flash:/c2950-i6q4l2-mz.121-19.EA1c.bin"...#############################
################################################################################
################################################################################
################################################################################
#####################

File "flash:/c2950-i6q4l2-mz.121-19.EA1c.bin" uncompressed and installed, entry
point: 0x80010000
executing...

              Restricted Rights Legend

Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.

           cisco Systems, Inc.
           170 West Tasman Drive
           San Jose, California 95134-1706

Cisco Internetwork Operating System Software
IOS (tm) C2950 Software (C2950-I6Q4L2-M), Version 12.1(19)EA1c, RELEASE SOFTWARE
 (fc2)
Copyright (c) 1986-2004 by cisco Systems, Inc.
Compiled Mon 02-Feb-04 23:29 by yenanh
Image text-base: 0x80010000, data-base: 0x8058A000

Initializing flashfs...
flashfs[1]: 78 files, 3 directories
flashfs[1]: 0 orphaned files, 0 orphaned directories
flashfs[1]: Total bytes: 7741440
flashfs[1]: Bytes used: 5982208
flashfs[1]: Bytes available: 1759232
flashfs[1]: flashfs fsck took 7 seconds.
flashfs[1]: Initialization complete.
Done initializing flashfs.
POST: System Board Test : Passed
POST: Ethernet Controller Test : Passed
ASIC Initialization Passed

POST: FRONT-END LOOPBACK TEST : Passed
cisco WS-C2950C-24 (RC32300) processor (revision P0) with 20808K bytes of memory
.
Processor board ID FOC0814W0T4
Last reset from system-reset
Running Enhanced Image
26 FastEthernet/IEEE 802.3 interface(s)

32K bytes of flash-simulated non-volatile configuration memory.
Base ethernet MAC Address: 00:0F:90:81:98:00
Motherboard assembly number: 73-5750-13
Power supply part number: 34-0965-01
Motherboard serial number: FOC081409Z7
Power supply serial number: DAB08135KRN
Model revision number: P0
Motherboard revision number: A0
Model number: WS-C2950C-24
System serial number: FOC0814W0T4

         --- System Configuration Dialog ---

Would you like to enter the initial configuration dialog? [yes/no]: n

Press RETURN to get started!

Switch>enable

Switch#erase startup-config
Erasing the nvram filesystem will remove all configuration files! Continue? [confirm]y[OK]
Erase of nvram: complete

Switch#delete vlan.dat
Delete filename [vlan.dat]? y
Delete flash:y? [confirm]y
%Error deleting flash:y (No such file or directory)

Switch#reload
Proceed with reload? [confirm]y
00:01:51: %SYS-5-RELOAD: Reload requested

C2950 Boot Loader (C2950-HBOOT-M) Version 12.1(11r)EA1, RELEASE SOFTWARE (fc1)
Compiled Mon 22-Jul-02 17:18 by antonino
WS-C2950C-24 starting...
Base ethernet MAC Address: 00:0f:90:81:98:00
Xmodem file system is available.
Initializing Flash...
flashfs[0]: 77 files, 3 directories
flashfs[0]: 0 orphaned files, 0 orphaned directories
flashfs[0]: Total bytes: 7741440
flashfs[0]: Bytes used: 5981184
flashfs[0]: Bytes available: 1760256
flashfs[0]: flashfs fsck took 7 seconds.
...done initializing flash.
Boot Sector Filesystem (bs:) installed, fsid: 3
Parameter Block Filesystem (pb:) installed, fsid: 4
Loading "flash:/c2950-i6q4l2-mz.121-19.EA1c.bin"...#############################
################################################################################
################################################################################
################################################################################
#####################

File "flash:/c2950-i6q4l2-mz.121-19.EA1c.bin" uncompressed and installed, entry
point: 0x80010000
executing...

              Restricted Rights Legend

Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.

           cisco Systems, Inc.
           170 West Tasman Drive
           San Jose, California 95134-1706

Cisco Internetwork Operating System Software
IOS (tm) C2950 Software (C2950-I6Q4L2-M), Version 12.1(19)EA1c, RELEASE SOFTWARE
 (fc2)
Copyright (c) 1986-2004 by cisco Systems, Inc.
Compiled Mon 02-Feb-04 23:29 by yenanh
Image text-base: 0x80010000, data-base: 0x8058A000

Initializing flashfs...
flashfs[1]: 77 files, 3 directories
flashfs[1]: 0 orphaned files, 0 orphaned directories
flashfs[1]: Total bytes: 7741440
flashfs[1]: Bytes used: 5981184
flashfs[1]: Bytes available: 1760256
flashfs[1]: flashfs fsck took 7 seconds.
flashfs[1]: Initialization complete.
Done initializing flashfs.
POST: System Board Test : Passed
POST: Ethernet Controller Test : Passed
ASIC Initialization Passed

POST: FRONT-END LOOPBACK TEST : Passed
cisco WS-C2950C-24 (RC32300) processor (revision P0) with 20808K bytes of memory
.
Processor board ID FOC0814W0T4
Last reset from system-reset
Running Enhanced Image
26 FastEthernet/IEEE 802.3 interface(s)

32K bytes of flash-simulated non-volatile configuration memory.
Base ethernet MAC Address: 00:0F:90:81:98:00
Motherboard assembly number: 73-5750-13
Power supply part number: 34-0965-01
Motherboard serial number: FOC081409Z7
Power supply serial number: DAB08135KRN
Model revision number: P0
Motherboard revision number: A0
Model number: WS-C2950C-24
System serial number: FOC0814W0T4

         --- System Configuration Dialog ---

Would you like to enter the initial configuration dialog? [yes/no]: n

Press RETURN to get started!

00:00:14: %SPANTREE-5-EXTENDED_SYSID: Extended SysId enabled for type vlan
00:00:18: %SYS-5-RESTART: System restarted --
Cisco Internetwork Operating System Software
IOS (tm) C2950 Software (C2950-I6Q4L2-M), Version 12.1(19)EA1c, RELEASE SOFTWARE
 (fc2)
Copyright (c) 1986-2004 by cisco Systems, Inc.
Compiled Mon 02-Feb-04 23:29 by yenanh
00:00:21: %LINK-5-CHANGED: Interface Vlan1, changed state to administratively do
wn
00:00:22: %LINK-3-UPDOWN: Interface FastEthernet0/24, changed state to up
Switch>
00:00:22: %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan1, changed state t
o down
00:00:23: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/24, chan
ged state to down
00:00:24: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/24, chan
ged state to up

Switch>enable

Switch#config terminal

Enter configuration commands, one per line.  End with CNTL/Z.

Switch(config)#enable password cisco
Switch(config)#end
Switch#write memory